PR Series Rod
Our PR and MPR series precision rods are designed to be used with our PRH precision rod holders and ARH adjustable rod holders. These support rods are cross drilled, except the PR-1.0, to accept a 3/16 hex wrench. This cross hole enables secure tightening to the device being supported. Attachment to the support rod is either by an 8-32(M4) stud on one end or by a 1?4-20(M6) tapped hole on the opposite end. PR precision rods come in six lengths from 1- to 12-inches and can be attached end-to-end with a set screw if greater lengths are needed. These precision support rods are compatible with CR-0.5, UC-0.5, and RTC-0.5 rod clamps.
Our MPR series miniature precision rods are designed to be used with our MRH miniature precision rod holders and RTC-0.3 clamps. Attachment to the support rod is by an 8-32 stud on one end. MPR miniature precision rods come in four lengths from 1.0- to 3.0-inches. By removing the 8-32 set screw from one rod, the overall length of a unit can be increased by screwing another rod to it. These miniature precision support rods are compatible with CR-0.3 and UC-0.3 rod clamps. MPR miniature precision rods and MRH miniature rod holders are machined to tight tolerance levels to guarantee a quality fit between parts.
- Stainless steel construction
- 1/4-20(M6) and 8-32(M4) interfaces
- PRH series is cross drilled for secure attachment
- VC versions available upon request